120
B 215 / B 225 Evo
Operator’s manual
19. OTHER MESSAGES
OP.1
- This message indicates the valve of the wheel that must be brought to
the 12 o'clock position during phases 1 and 5 of optimisation (OPt).
OP.2 180
- This message indicates that the position of the valve must be moved
180° with respect to the previous position (12 o'clock).
Out 2
- This message is displayed when the improvement obtained by optimi-
sation is not sufficient.
- Press the
key to exit the program or the
key to continue
the optimisation phase.
Abo rt
- Notice PREMATURE EXIT from the unbalance optimisation program.
- Press the
key to confirm or the
key to remain in the
programme.
--I- -I--
- Notice TYRE MOUNTING INVERSION ON THE RIM in the OP.5 phase
of the programme.
If you do not want to (or cannot) carry out this operation, press the
key. the machine will provide the instructions to complete
the programme without inversion.
HId dEn
- This message indicates that the operator is in the “positioning the weights
behind the spokes Hidden Weight” programme.
no no
- This message is displayed if the wheel is balanced on the outer side.
in -1-
- This message indicates that the machine is set for acquiring the P1 posi-
tion behind the first spoke
in -2-
- This message indicates that the machine is set for acquiring the P2 posi-
tion behind the second spoke.
no -2-
- This message is displayed for approx. 3 seconds if the selected angle is
greater than 120 degrees, indicating that the procedure must be repeated
correctly.
in H.X
- This message indicates the reference for acquiring the two points P1 and
P2 behind the spokes. Depending on the configuration performed by
the operator, the message on the display can be H3, H6 or H12. If the
laser indicator is enabled, the reference will be 6 o'clock (H.6).
CAL GO
- Calibration spin.
I - - CAL
- This message indicates the correct position for applying the calibration
weight in the unbalance calibration programme at the end of the first spin.
