HP x280n - MediaSmart Connect - Digital Multimedia Receiver, Installation And User Manual

Page: 47 / 256

Chapter 3: Using the Remote Control 47
7 Repeat steps 1 through 6 for each device you want to control
with the remote control.
This completes programming a primary device. You can now
program a second device for volume mapping for each primary
device; see “Programming a second device for volume mapping”
on page 47.
Programming a second device for
volume mapping
Volume mapping defines a device instead of the TV or primary
device as producing sound. Pressing the Volume buttons or the
Mute button sends an IR remote control code to adjust the sound
level at the second device without requiring you to change the
controlled device on the remote control.
For the HP MediaSmart Connect and each device (TV, CBL, DVD,
or AUX) you program to control with the remote control, you can
program a second device for volume mapping. When you
reprogram the primary device, you must also reprogram the
volume mapping device.
Follow these steps to program the remote control second device
for volume mapping:
1 Locate the brand of your second device and the manufacturer
codes. For device manufacturer codes, see the listing on the
HP Web site at:
http://www.hp.com/support/mediasmart
2 Turn on the device you want to program as a second device
for volume mapping.
3 Press the Device button on the remote control one or more
times to select the primary device (HP MediaSmart Connect,
TV, CBL, DVD, AUX). Wait until the device indicator light on
the remote control goes out.
4 Press and hold down the Device button on the remote control
for 5 seconds, until the device indicator light blinks, and then
release the Device button. The device indicator light blinks
one more time and then remains lit, indicating the remote
control is in programming mode.
5 Press one of the Volume buttons on the remote
control.