Overview
34
Director 2/64 Installation Guide
Tools and Test Equipment
This section describes tools and test equipment that may be required to test,
service, and verify operation of the director and attached HAFM server. These
tools are either supplied with the director or must be supplied by service
personnel.
Tools Supplied with the Director
The following tools are supplied with the director. Use of the tools may be
required to perform test, installation, service, or verification tasks.
■
Torque tool with hexagonal adapter—The torque tool with 5/32”
hexagonal adapter, as shown in
Figure 4
, is required to remove and replace
director logic cards.
Caution:
The torque tool supplied with the Director 2/64 is designed to
tighten director logic cards and is set to release at a torque value of six
inch-pounds. Do not use an Allen wrench or torque tool designed for use with
another HP product. Use of the wrong tool may overtighten and damage logic
cards.
Figure 4: Torque tool and hex adapter
■
Loopback plug—An SFP multi-mode (shortwave laser) or single-mode
(longwave laser) loopback plug, as shown in
Figure 5
, is required to perform
port loopback diagnostic tests. One loopback plug is shipped with the
director, depending on the type of port transceivers installed. Both plugs are
shipped if shortwave laser and longwave laser transceivers are installed.
