HP StorageWorks 7110 - Virtual Array, Service Manual, Page: 118 / 164

118 Servicing & Upgrading
Figure 46 Removing & Installing an Array Controller Battery
Installing an Array Controller Battery
1 Seat the battery connector ( Figure 47 , 1) on the battery terminal (2).
2 Lay the battery ( Figure 47 , 3) on the foam pad (4) and in the battery
bracket (5).
3 Place the battery clamp ( Figure 46 , 2) on the battery (3).
4 Slide the battery clamp forward so that the front tabs ( Figure 46 , 4) are
positioned under the bulkhead tabs (5).
5 Tighten the battery clamp screw ( Figure 46 , 1) with a T-20 driver.
6 Replace the array controller card. See "Installing an Array Controller" on
page 110 .
Note If the array controller battery was replaced on a single array
controller, wait for the battery to charge before resuming I/Os.
5
4
2
3
1