104 Servicing & Upgrading
Fiber Optic Cables
Caution
To prevent damage to fiber optic cables: 1) Do not exceed a
bend radius of 2 inches (5.1 cm). 2) Grasp the connector when
disconnecting a fiber optic cable; never pull on the cable. 3)
Install fiber optic covers (see
Figure 38
) after a cable is removed.
Figure 38
Fiber Optic Covers
Removing & Installing Fiber Optic Cables
See
Figure 39
and
Figure 40
to remove and replace fiber optic cables.
Note
The array controller uses one of two types of fiber optic cable
connectors:
—
SC connectors (Figure 39, 1) are large-form-factor connectors that plug
into the GBIC (Figure 39, 2) on VA 7100 array controller cards. The
GBIC then plugs into the HOST FC connector on the array controller
card.
—
LC connectors (Figure 40, 1 and 2) are small-form-factor connectors
that plug directly into the DISK FC and HOST FC connectors on
VA 7110/7400/7410 array controller cards.
—
Both SC and LC connectors are keyed to install only one way.
Summary of Contents for StorageWorks 7110 - Virtual Array
