HP StorageWorks 2/16 - SAN Switch, Manual

Page: 79 / 250

Diagnostic and system error messages reference guide
79 Fabric OS 3.x Document Addendum
For an unauthorized switch in the SCC policy, add the switch WWN to the SCC policy, using
the
secpolicyadd
command.
For a certificate retrieve error, make sure the switch certificate is properly installed, using the
pkishow
command. Reinstall the certificate, if necessary, using the
pkicert
command.
For a secret retrieve error, make sure that the secret values are properly set. Reset the secret
values using the
secauthsecret
command.
For other internal errors (for example, bad payload, incorrect field length, or invalid object),
this might be a transient error. Use the
switchdisable
and
switchenable
commands
or
portdisable
and
portenable
commands to determine whether the problem is
consistent.
Other errors (for example, invalid nonce, signature, reply message, or response value) might
indicate that an invalid entity is trying to connect to the switch. Check the connection port to
verify that there is no security attack. Otherwise, use the
switchdisable
and
switchenable
commands or
portdisable
and
portenable
commands to determine
whether the problem is consistent.
Severity
ERROR
CONFIG-PIDCHANGE_EXTENDED_EDGE
Message
Probable Cause
The PID format for the fabric was changed to Format 2, extended-edge PID. For more
information on PID format, refer to the HP StorageWorks Fabric OS Procedures Version
3.1.x/4.1.x User Guide.
Recommended Action
This message is for information purposes only. The entire fabric must be configured with the
same PID format or the fabric segments.
Severity
WARNING
<timestamp>
WARNING CONFIG-PIDCHANGE_EXTENDED_EDGE, 3, Switch PID format changed to
Format 2 ('Extended Edge PID Format').