HP ProLiant WS460c Gen9, Maintenance And Service Manual, Page: 49 / 102

Removal and replacement procedures 49
graphics expansion control cable is installed, the long cable will be connected in the lower
connector on the riser.
To replace the component, reverse the removal procedure.
FlexibleLOM
To remove the component:
1.
Power down the graphics server blade (on page 25 ).
2.
Remove the graphics server blade (" Remove the graphics blade " on page 26 ).
3.
Place the graphics server blade on a flat, level work surface.
4.
Remove the access panel (" Access panel (graphics server blade) " on page 31 ).
5.
Remove the mezzanine assembly (" Mezzanine assembly " on page 34 ).
6.
Use the FlexibleLOM handle to remove the FlexibleLOM from the system board.
To replace the component, reverse the removal procedure.