IMPORTANT:
Make special note of each screw and screw lock size and location during removal and
replacement
Before removing the RTC battery, follow these steps:
1.
Shut down the computer.
2.
Disconnect all external devices connected to the computer.
3.
Remove the following components:
a.
Service door (see
Service door on page 37
).
b.
Remove the battery (see
Battery on page 38
)
c.
Hard drive (see
Hard drive on page 39
).
d.
Solid-state drive (see
Solid-state drive (select products only) on page 41
).
e.
WWAN module (see
WWAN module (select products only) on page 42
).
f.
WLAN module (see
WLAN module on page 44
).
g.
Optical drive (see
Optical drive on page 46
).
h.
Keyboard (see
Keyboard on page 48
).
i.
Hinge covers (see
Hinge cover on page 55
).
j.
Base enclosure (see
Base enclosure on page 57
).
k.
System board (see
System board on page 59
).
l.
Fan/heat sink assembly (see
Fan and heat sink assembly on page 61
).
m. Top cover (see
Top cover and TouchPad on page 65
).
To remove the RTC battery:
▲
If not already disconnected, disconnect the cable, and then remove the RTC battery.
Component replacement procedures
69
Summary of Contents for ProBook 640 G2
