IMPORTANT:
Make special note of each screw and screw lock size and location during removal and
replacement
Before removing the system board, follow these steps:
1.
Shut down the computer.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the following components:
a.
Service door (see
Service door on page 37
).
b.
Battery (see
Battery on page 38
).
c.
Hard drive (see
Hard drive on page 39
).
d.
Solid-state drive (see
Solid-state drive (select products only) on page 41
).
e.
WWAN module (see
WWAN module (select products only) on page 42
).
f.
WLAN module (see
WLAN module on page 44
).
g.
Optical drive (see
Optical drive on page 46
).
h.
Keyboard (see
Keyboard on page 48
).
i.
Hinge covers (see
Hinge cover on page 55
).
j.
Base enclosure (see
Base enclosure on page 57
).
Remove the system board:
1.
Disconnect the RTC battery cable (2) and the power button board cable (2).
2.
Loosen 3 P1 captive screws (1) on the fan, remove 4 M2x3L P1 screws (2) from the system board, and
remove 2 M2x3L screws from the ODD board (3).
60
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Summary of Contents for ProBook 640 G2
