Before removing the memory module, follow these steps:
1.
Shut down the computer.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the following components:
a.
Service door (see
Service door on page 37
).
b.
Battery (see
Battery on page 38
).
c.
Hard drive (see
Hard drive on page 39
).
d.
Solid-state drive (see
Solid-state drive (select products only) on page 41
).
e.
WWAN module (see
WWAN module (select products only) on page 42
).
f.
WLAN module (see
WLAN module on page 44
).
g.
Optical drive (see
Optical drive on page 46
).
h.
Keyboard (see
Keyboard on page 48
).
▲
If you are replacing a memory module, remove the existing memory module:.
▲
Pull away the retention clips (1) on each side of the memory module.
The memory module tilts up.
▲
Grasp the edge of the memory module (2), and then gently pull the memory module out of the
memory module slot.
CAUTION:
To prevent damage to the memory module, hold the memory module by the edges only. Do
not touch the components on the memory module.
To protect a memory module after removal, place it in an electrostatic-safe container.
To install a memory module:
52
Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Summary of Contents for ProBook 640 G2
