HP NetServer e 800, Service Manual

Page: 95 / 103

Chapter 6 Replacing Parts
89
Retaining Latches
DIMM Slot
Keys
Notches
DIMM to Slot Alignment
e. Holding the DIMM at 90 degrees to the system board, press the DIMM fully into the slot until
the retaining latches close.
f. If the latches do not close, the DIMM is not inserted correctly.
2. Repeat all of Step 1, to install the additional DIMMs for your memory configuration.
3. Replace the air duct and latch it into the chassis.
4. Replace the cover.
5. Fasten the six thumbscrews securing the cover to the chassis.
6. Replace the external cables and power cord.
7. Power up the NetServer as described in Chapter 1.
NOTE Most DIMMs are dimensionally identical, so, if you have two or more DIMMs
installed, you may verify all DIMMs are seated by sliding a straight edge (a pen, for
example) across the top edges and verify it remains in continuous contact with all of
the DIMMs.
8. If the DIMMs are not seated properly you may get a blank screen.
Accessory Boards
Removing Accessory Boards
To remove an accessory board, refer to the following procedure
1. If the NetServer is operating, power down the NetServer.
2. Disconnect the power cord and any external cables connected to the NetServer. If necessary,
label each one to expedite re-assembly.
3. Remove the cover and turn in the NetServer feet (so that the NetServer will lie flat on its side).
WARNING The power supply will continue to provide standby current to the NetServer E 800
until the power cord is disconnected.