HP NetServer e 800, Service Manual

Page: 45 / 103

Chapter 4 Diagnostics
39
Code Description Problem/Solution
4. If the problem persists, your hard disk drive may
need to be replaced. Contact your service
representative.
053X Hard Disk drive connection
problem
(This does not apply to
E 800)
(Error code #0530 is the
primary channel cable IDE1
and #0531 is the secondary
channel cable IDE2) POST has detected a hard disk drive on the second <slave>
position on the IDE cable, but no hard disk has been found
on the first <master> position.
To correct this:
1. If only one hard disk is connected on the cable,
disconnect the hard drive and use the other
connector to re-connect the hard drive into the first
<master> position.
2. If two disks are connected on the cable, verify all
data cables and power cables are firmly connected
for both hard disk drives.
3. If the error message appears just after a hard disk
drive installation, check for master/slave specific
jumper configurations in the hard disk drive
installation manual.
4. If the problem persists, the hard disk drive may need
to be replaced. Contact your service representative.
0540 Hard Disk Controller
resource conflict POST has detected an address space or IRQ resource
conflict between the integrated hard disk controller and an
accessory board.
To correct this:
1. If the integrated hard disk controller is not needed,
run the Setup Utility to disable it (primary or
secondary).
2. If the integrated hard disk controller is needed, the
accessory board's IRQ and address space must be
reconfigured to use other free resources. Refer to the
accessory board installation manual for information.
0600 Video Memory boot error
(This does not apply to
E 800) The video memory size detected during POST is smaller than
previously detected.
To correct this:
1. If you have changed your video adapter, press <F4>
to automatically validate the change.
2. If the problem persists, the system board may need
to be replaced. Contact your service representative.
0700 DIMM size boot error The system memory size detected during the POST is
smaller than previously detected. One or several DIMMs are