The server blade should come up to standby power. The server blade is at standby power if the blade
power LED is amber.
Server blade power states
The server blade has three power states: standby power, full power, and off. Install the server blade into
the enclosure to achieve the standby power state. Server blades are set to power on to standby power
when installed in a server blade enclosure. Verify the power state by viewing the LEDs on the front panel,
and using
Table 5: Power States
Power States
Server Blade
Installed in
Enclosure?
Front Panel Power
Button Activated?
Standby Power
Applied?
DC Power
Applied?
Standby power
Yes
No
Yes
No
Full power
Yes
Yes
Yes
Yes
Off
No
No
No
No
Powering on the server blade
Use one of the following methods to power on the server blade:
NOTE:
To power on blades in a conjoined configuration, only power on the Monarch blade. See
for rules on the definition of the Monarch blade.
• Use a virtual power button selection through iLO 3.
• Press and release the Monarch power button.
When the server blade goes from the standby mode to the full power mode, the blade power LED
changes from amber to green.
24
Server blade power states
Summary of Contents for Integrity BL860c i4
Page 7: ...W 163 Contents 7 ...
