2–60
HSG80 Array Controller V8.7 Command Line Interface Reference Guide
CLI Command Descriptions
Deletes a specified connection from the table of known connections maintained by the
controller, whether or not the host adapter is still physically connected to a controller
port.
The table of known host connections is maintained in the controller’s memory. Once a
connection is added to the table, it stays there, even if the physical connection between
host adapter and controller port is severed. The only way to remove a connection from
the table is through this command.
NOTE: A connection with an access path explicitly enabled on a unit cannot be deleted. Access
path is enabled explicitly through the ENABLE_ACCESS_PATH qualifier of the ADD UNITS or
SET unit commands. If access path is generically enabled for all connections
(ENABLE_ACCESS_PATH= ALL), then any or all connections can be deleted. A connection
with explicit access path must have the access path disabled (through the
DISABLE_ACCESS_PATH qualifier of the SET unit command) before the connection can be
deleted.
Syntax
DELETE connection-name
Parameters
connection-name
The name given to the host connection. The connection name is one of the
following:
•
The default name assigned to the host connection when it was physically
connected to the controller port. Default names are of the form!NEWCONnn.
•
The name given through the RENAME command.
•
The name given through the ADD CONNECTIONS command.
Switches
There are no switches associated with this command.
DELETE
connection-name