HP HP ProCurve Series 6600, Access Security Manual

Page: 100 / 778

2-46
Configuring Username and Password Security
Password Recovery
5. Do one of the following after the “
CAUTION
” message appears:
• If you want to complete the command, press
[Y]
(for “Yes”).
• If you want to abort the command, press [N] (for “No”)
Figure 2-23 shows an example of disabling the password-recovery parameter.
Figure 2-23. Example of the Steps for Disabling Password-Recovery
Password Recovery Process
If you have lost the switch’s manager username/password, but
password-
recovery
is enabled, then you can use the Password Recovery Process to gain
management access to the switch with an alternate password supplied by HP.
N o t e
If you have disabled
password-recovery
, which locks out the ability to recover a
manager username/password pair on the switch, then the only way to recover
from a lost manager username/password pair is to use the Reset+Clear button
combination described under “Restoring the Factory Default Configuration”
on page 2-36. This can disrupt network operation and make it necessary to
temporarily disconnect the switch from the network to prevent unauthorized
access and other problems while it is being reconfigured.
To use the
password-recovery
option to recover a lost password:
1. Note the switch’s base MAC address. It is shown on the label located on
the upper right front corner of the switch.
2. Contact your HP Customer Care Center for further assistance. Using the
switch’s MAC address, the HP Customer Care Center will generate and
provide a “one-time use” alternate password you can use with the to gain
management access to the switch. Once you gain access, you can config-
ure a new, known password.
HP Switch(config)# no front—panel—security password—recovery
**** CAUTION ****
Disabling the clear button without password recovery prevents switch passwords
from being reset. If the switch password is lost, restoring the default factory
configuration will be required to regain access!
Continue with disabling password recovery [y/n]? y
HP Switch(config)# _