Technical specifications
Table 1-26
Technical specifications for the FIP-210
Item
Specifications
Processor
MIPS 1GHz
Processor cores
8
Flash
4 MB
Memory type and size
DDR2 SDRAM
2 GB (default, two 1 GB memory modules)
2 GB (maximum)
NVRAM
128 KB
Combo interfaces
2
2 electrical interfaces
(automatic MDI/MDI-X)
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
2 optical interfaces
1000 Mbps, full-duplex
HIMs
2
MIMs
2
Dimensions (H × W × D)
45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in.)
Hardware encryption
Supported
Power consumption
125 W
Hot-swapping
Supported
For a Combo interface, the default operating interface is the electrical interface.
For a Combo interface, you can use either the electrical Ethernet interface or the optical
Ethernet interface. You can use the
combo enable
{
copper
|
fiber
} command in interface
view to switch between the optical and electrical interfaces. For details about the
combo
enable
{
copper
|
fiber
} command, refer to
Ethernet Interfaces
in the
Access Volume
of
HP
SR6600 Routers User Manual
.
Use optical transceivers provided by HP only. The device may be incompatible with other
optical transceivers and thus displays alarms automatically.
"Hot-swapping" a module refers to first using the
remove slot
slot-number
command to stop
the module, and then manually pulling it out, or inserting the module into its slot without
powering off the device. For details about the
remove slot
command, refer to
Device
Management
in the
System Volume
of
HP SR6600 Routers User Manual
.
