HP 70000 series, User Manual

Page: 323 / 447

Operating Errors 2000 { 2999
2019
Illegal marker type
Cause: The command executed does not apply to the marker mode of the markers on the
display . F or example , if a normal marker is on screen, and the \Marker delta into span"
function is activated, the function cannot be executed, and the error will occur .
Cure: Refer to the programming or operation manual for the function being executed to
determine the proper marker type for the operation.
2020
No active marker
Cause: This error occurs when Marker Delta is moved to Center Frequency Step Size (MKSS)
while no markers are active .
2021
Bad IF/ENDIF nesting
Cure: Use the DEBUG command to locate the programming error . Refer to the HP 70000
Modular Spectrum Analyzer Programming Manual.
2022
REPEAT/UNTIL error
Cure: Use the DEBUG command to locate the programming error . Refer to the HP 70000
Modular Spectrum Analyzer Programming Manual.
2023
Illegal Cal signal
Cause: Calibration signal did not match.
2024
Illegal HP-MSIB comm
Illegal HP-MSIB communication
Cause: An HP-MSIB protocol violation has occurred.
Cure: Document all steps leading up to the error condition and contact your HP representative .
2025
System error (slave)
Cause: HP-MSIB communications with a slave module has created this error .
Cure:
Record the error number and the hexadecimal code .
Record all events that led up to the occurrence of the error message .
Record the HP model numbers of the modules in the system.
Record the rmware version.
6-16 Error Messages