HP 33120A, User Manual

Page: 19 / 118

To verify that the state was stored properly, you can turn the power off
before recalling the state.
5 Recall the stored instrument state.
To recall the stored state, you must use the same memory location used
previously to store the state. Use the up and down arrow keys to change
the displayed storage location.
RECALL 2
To cancel the restore operation, press
Recall
again.
This message appears on the display for approximately 10 seconds.
Repeat this step as needed.
6 Restore the instrument state.
The function generator should now be configured in the same state as
when you stored the setup on the previous page.
When power is turned off, the function generator automatically stores
its state in memory location “0”. You can recall the power-down state,
but you cannot store the state to location “0” from the front panel.
Use the POWER ON LAST STATE command in the SYS MENU to
automatically recall the power-down state when power is turned on.
See chapter 2 for more information on using the front-panel menus.
Recall
Enter
Chapter 1 Quick Start
To store the instrument state
26