Hospira GemStar Series, System Operating Manual

Page: 169 / 221

Chapter 14. Operation Test
160 Hospira GemStar System Operating Manual
Power Check
1
The display indicates that an external power source and batteries are connected.
Press .
2
Remove battery door and press . The display indicates that only external
power is connected. Press .
3
Return the battery door to the closed position.
4
Disconnect the external power source and press .
5
The display indicates that only batteries are connected and displays the test
results. Press .
6
If the pump fails, reconnect the external power source and press to rerun the
test, or press [
YES/ENTER
] to confirm failure.
Keypad Test
1
Press each key, including the Bolus Button. Press [
YES/ENTER
] last.
2
Enter the results:
•
If each key makes an audible tone, press [
YES/ENTER
].
• If any key does not make an audible tone, press [
NO
].
Display Test
1
Press [
YES/ENTER
] when prompted. The display fills with solid boxes for
approximately 10 seconds. To view the solid boxes for another 10 seconds after
the display times-out, press .
2
Enter the results:
•
If the display fills with solid boxes, press [
YES/ENTER
].
• If the display does not fill with solid boxes, press [
NO
].
f
Tip: Opening the battery compartment door will disconnect the batteries enough for
the pump to recognize external power. Then the door can be tightened and testing
can continue. This can save time when performing multiple tests on a group of pumps.