Hospira GemStar Series, System Operating Manual

Page: 149 / 221

Chapter 12. Troubleshooting
140 Hospira GemStar System Operating Manual
CHECK CASSETTE-X
N A/V The cassette is
improperly installed
or not installed.
X
indicates where to
look for the cause of
the alarm:
D = Distal
P = Proximal
1 Press [
SILENCE
] to quiet
the alarm for 1 minute.
2 Press [
STOP
] to place the
pump in the
STOP
mode.
3 Ensure slide clamp or lower
CAIR clamp is open prior to
inserting cassette.
4 Reinstall the cassette.
CAUTION: Ensure all
four cassette latches
are clearly visible after
the cassette is installed.
Note: Ensure the tubing is
behind the tubing guide (at the
distal end). Refer to Loading
the Cassette
o
n page 35.
5 Press [
START
] to begin
infusion.
Note: The pump cannot be
powered off during a CHECK
CASSETTE alarm (except
during
PROGRAMMING
mode).
CALL
1.800.XXX.XXXX
CODE: NN/MMM/TTT
[SERVICE ALARM]
N A/V The pump has
detected a condition
that may require
service.
1 Write down the telephone
number and code.
2 Power-off the pump. If the
pump does not power-off,
disconnect external power
and remove the batteries.
3 Call the telephone number
shown on the display
message.
Alarm Display
Message
Is the
pump
infusing?
Alarm Cause/
Condition
Remedy
Y = Yes
N = No
A = Audible alarm
V = Visual alarm