horsch LEEB 12 TD, Operating Instructions Manual, Page: 157 / 181

9. Grease the bearing shall in the mounted hub.
10. Fill grease between the tapered rollers and
cage of the bearing until the rollers are com-
pletely covered.
11. Remove old grease from the dust cap and
clean thoroughly.
12. Fill the cap with long-term grease before
reassembling it.
13. Mount the wheel hub and axle nut again.
14. Adjust the bearing and brake settings.
15. Perform a function check and corresponding
test drive after the adjustment. Correct any
detected deficiencies immediately.
NOTE
¾
For lubricating the wheel hub bearings one
should only use special long-term grease with
a dropping point higher than 190 °C.
¾
Wrong grease types and excessive quantities
can cause damage.
¾
Mixing lithium saponified and monosodium
carbonate saponified greases can cause
damage because of incompatibility.
152 153