horsch LEEB 12 TD, Operating Instructions Manual, Page: 111 / 181

Flush the respective preparation through the
illuviation valve into the water of the spraying
mixture container. A difference is in this case
made between the illuviation of fluid and
powdery preparations or carbonyl diamide.
1
2
3
4
5
1 Activate/deactivate the canister flushing
2 Activate/deactivate the washing gun
3 Activate/deactivate the shock nozzle (only
with illuviation valve from stainless steel)
¾
for illuviation valve with plastic funnel: A
rinsing nozzle is activated in the lower
area of the valve.
¾
for illuviation valve with stainless steel
funnel: Two rinsing nozzles and the shock
nozzles in the lower area of the valve are
activated.
4 Activate/deactivate closed circuit flushing
5 Switch-over ball valve sucking-off / Ecofill
Flushing in liquid preparations
during the filling process on
machines of the CCS Pro variant
1. Enter the desired container content in the
terminal
2. Connect the suction hose to the filling
connection.
Filling connection
3. Start filling via terminal.
4. Switch on the illuviation valve on the terminal.
5. Open the lid on the illuviation valve.
6. Fill the preparation quantity calculated and
measured for filling the tank into the illuviation
valve.
7. Turn the switch-over ball valve (e) to the
position for sucking-off. Have the content
completely sucked off from the illuviation
valve.
8. Close the switch-over ball valve (e) again.
The process may need to be repeated if the
required preparation could not be filled in
during a single process.
9. Pre-clean the illuviation valve with the closed
circuit flushing (d).
10. Open the switch-over ball valve and have
the contents sucked off.
11. Close the switch-over ball valve (e) again.
12. Switch off the illuviation valve on the
terminal.
13. Top up the water shortfall.
14. Adjust the desired agitator power.
106 107