35
Operating Procedures
2-10
Setting the KTU-35 Cross Folder
Locking Screw
Buckle Stopper Angle
Adjusting Knob
Buckle Stopper Jog Adjusting Knob
Buckle Stopper
Set Screw
Buckle and Deflector Settings
When you are not using a buckle plate to
do folding, install the deflector.
- Lock the deflector using the set screw.
Deflector
Set Screw
Deflector
Set the buckle stopper.
1) Calculate the fold position.
Refer to the table on page 27.
2) Loosen the buckle stopper set screw and move
the buckle stopper to the position calculated
in set 1).
Install the buckle plate.
1) Lift the buckle set lever and slide the buckle
plate under the block.
2) Lower the buckle set lever to hold the buckle
plate.
Buckle Set Lever
Block
When not using the deflector, put it in the position
shown in the figure below.
Deflector
3) If necessary, make a fine adjustment of the
position of the buckle stopper.
- Turn the buckle stopper angle adjusting
knob and the buckle stopper jog adjusting
knob to adjust.
- Loosen the locking screw before turning the
buckle stopper angle adjusting knob.
The buckle stopper angle adjusting knob is use to set
the angle of the buckle stopper.
Setting the KTU-35 Cross Folder