31
Operating Procedures
2-10
Setting the KTU-35 Cross Folder
Top/Bottom Guide Settings
Repercussion Prevention Brush Settings
Set the bottom guides to support the
sheets. (Set each guide in a space be-
tween the belts.)
Also set the top guides to control the
sheets.
Stoppers
Hook this part over the
supporting bar.
Hook this part over the
supporting bar.
- Place the entrance end of each top guide above the
belt so that the belt provides more “drive.”
- Place the delivery end of each top guide near the
bottom guide to prevent the sheet from being bent.
(The top guides can be set diagonally.)
Repercussion Prevention Brush
Position the repercussion prevention
brushes.
- Move each brush to a position where it slightly
touches one end of the sheet when the other
end is hitting the stopper.
Adjust the angle of each repercussion
prevention brush.
- Set each brush so it presses down against the
sheets.
Feed some sheets actually and check if the sheets are
transported smoothly. If not, raise the angle of the
brush.
Setting the KTU-35 Cross Folder