Horizon Fitness PC-P430, Manual

Page: 2 / 74

2
II Symbols used in this manual
Circuit configuration identification characters and symbols
1. Wiring color character code
BRN *=The (*) that follows the color mark is the dark gray band that is
attached to one of the wires for identification purposes when there are 2 of
the same color wires within the same bundle of wires.
RED/BLU = The /BLU that follows the color mark indicates that the mother
color of the wire is blue, and that on top there is a red colored stripe. *
* The following wiring color character
codes have been modified. The
new codes are used from January
2013.
- BLU/GRY (Grey)
→ BLU/LBLU (Light blue)
- BLU/VIO (Violet)
→ BLU/PNK (Pink)
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
Junction connector, or terminal board
Short circuit connector BL
2. Identification characters of electrical parts
Single color character code
BRN = Brown
= Brown
RED = Red = Red
GRY = Grey = Grey
YEL = Yellow = Yellow
GRN = Green = Green
BLU = Blue = Blue
VIO = Violet = Violet
WHT = White = White
BLK = Black = Black
ORN = Orange = Orange
PNK = Pink = Pink
LBLU = Light blue = Light blue
MOD =Module connector
NC =Normal [closed] contact terminal
NO =Normal [open] contact terminal
SSR =Solid state relay
VR =Volume
SIG =Signal voltage
S/N =Machine number
BSD =Block schematic diagram
*X## =* Connector
AC =Alternating current
BL =Short circuit connector
COM =Common terminal
CON =Connector
CW =Clockwise direction
CCW =Counterclockwise direction
DC =Direct current
DSW =Dip switch
F.G =Frame ground
GND =Ground
JSW =Jumper switch
Round connector (CPC)
PG** =Encoder
Q** = Circuit protector
/Breaker
QPM** =(Multi layer) board
QPW** =(Single layer) board
RY**
=Relay (on the board)
S** =Switch
T** =Transformer
X** =Terminal board/connector
Y** =Solenoid/clutch/Valve etc.
Z** =Noise Filter
A** =Inverter/driver/amplifier
B** =Sensor
C** =Capacitor
E** =Heater
F** =Fuse
G** =Power supply
H** = Indicating lamp
/illumination
K** =Contactor/relay/SSR
L** =Reactor
M** =Motor