Horizon Fitness PC-P430, Manual

Page: 23 / 74

Troubleshooting
2
The Last Few Sheets Are Left Uncut
PC-P430
23
2 - 6 The Last Few Sheets Are Left Uncut
Is the knife height OK?
404018
2_6_1B
■ If the last few sheets left uncut just after replacing the
knife, the knife height is not correct. See page 9
and lower the knife.
Are the cutting stick and the knife OK?
1
3
4
8
7
2
6 5
404018
2_6_1A
■ If there is a groove on the cutting stick as shown in
the drawing above, the last few sheets are left uncut,
or the cutting edge is rough. Change the cutting stick
face or replace it. If the groove is shallow and the last
one sheet is left uncut, place few sheets under the
cutting stick. Prepare the sheets whose width is the
same as the cutting stick.
■ If the knife edge is worn, the dull knife causes the
louder cutting noise and the last few sheets are left
uncut. Replace the knife. Service technicians should
bring back the used knife.
The wear of the knife can not be seen by the eyes. The repeated
operation with the dull knife may result in machine malfunction.
The knife needs to be replaced earlier.
Is the knife tilted?
404018
2_6_1C
■ If the sheets are left uncut on either side, see page
9 and adjust knife angle.
One side of a cutting
stick can provide two
working lines. One
cutting stick can provide
eight working lines on
the four sides
Cutting Stick
Lower
The adjustable range is ± 45 degrees. If
you turn the screw more, the screw may
be broken.
Right-hand Screw
Lock Nut
Loosen
Left-hand Screw
Lock Nut
Loosen
Adjusting
Screw
Locking Screw
Eccentric Pin