Honeywell VXP, System Maintenance Manual, Page: 47 / 105

Maintenance
VXP System Maintenance Manual 4-3
4.2.1.4 FasTrak Optical Tracker
The FasTrak Optical Tracker should be inspected per Table 4-5.
NOTE:
The infrared light-emitting diodes (LEDs) are factory aligned and may appear to
be pointing randomly. This configuration is normal.
Table 4-5. FasTrak Optical Tracker
Inspection Procedures Remedy
Exterior Inspect the housing for loose
screws. Remove any loose screws and
apply Loctite before
reinstalling them.
Inspect the filter window for
cracks or looseness. Return to Chadwick-Helmuth
for repair.
Inspect the filter window for
clarity. Clean the filter window with
any standard glass cleaner
and a soft, clean lint-free
cloth.
Inspect the cable connector
for bent or broken pins. Replace the cable connector
(see Section 5.2, Cable
Repair).
Inspect the Delrin mounting
base for general condition and
security. Closely inspect the
four mounting holes for
deformations, cracks, or
excessive wear. Return to Chadwick-Helmuth
for repair.
Interior Shake the unit and listen for
any loose internal
components. Return to Chadwick-Helmuth
for repair.
Looking through the filter
window, check the lens for
cleanliness, cracks, and
general alignment. Return to Chadwick-Helmuth
for repair.
The lens tube must be clear of
polished or reflective
surfaces, where the flat black
paint finish may have worn or
flaked away. Return to Chadwick-Helmuth
for repair.