62(96)
Control Keypad
Honeywell
Honeywell
Honeywell
Honeywell
7
7.4.3 Keypad control menu (K3)
In the
Keypad Controls Menu
, you can choose the control place, edit the frequency reference and
change the direction of the motor. Enter the submenu level with the
Menu button right
.
Parameters in Menu
K3
Selections
P3.1 = Selection of control
place
1 = I/O terminals
2 = Keypad
3 = Fieldbus
R3.2 = Keypad reference
P3.3 = Keypad direction
0 = Forward
1 = Reverse
P3.4 = Stop button activation
0 = Limited function of Stop
button
1 = Stop button always
enabled
P3.5 = PID reference 1
P3.6 = PID reference 2
7.4.3.1
Selection of control place
There are three different places (sources) which the frequency converter can be controlled from. For
each control place, a different symbol will appear on the alphanumeric display:
Control place
Symbol
I/O terminals
I/O term
Keypad (panel)
Keypad
Fieldbus
Bus/Comm
Change the control place by entering the edit mode with the
Menu button right
. The options can
then be browsed through with the
Browser buttons
. Select the desired control place with the
Enter
button
. See the diagram below. See also Chapter 7.4.3 above.
Figure 7-7. Selection of control place
enter
STOP
I/O
term
READY
STOP
I/O
term
READY
STOP
I/O
term
READY
STOP
I/O
term
READY
STOP
I/O
term
READY