Connect outputs
Galaxy Flex Installer Manual
20
The wiring of the terminator and keyswitch zone type is shown in the following figure:
Figure 7 Terminator and keyswitch zone wiring
Connect outputs
Outputs are addressed in the same way as the zones. If using on-board outputs, connect and
address as follows:
O/P
Address
Function
O/P type
Connection
1
1001
Bells
Open-collector,
switched negative
Connect load between OP1
and +12 V
2
1002
Strobe
Open-collector,
switched negative
Connect load between OP2
and +12 V
3
99
Exit/Entry (E/E) horn
AC audio to drive an
internal loudspeaker
Connect load (8–32
Ω
)
between OP3 and +12 V
If required, use the Program Outputs menu (
53 ent
) to modify the default settings.
Figure 8 A typical application
Secure the tamper circuits
1.
If an external siren/bell/warning device is fitted, connect the tamper return line from the
device to the T terminal.
2.
If an external siren/bell/warning device is not fitted, connect the T terminal directly to
the 0 V terminal.
3.
If a relay output is required, fit the Output Option Board.
4.
Replace and secure the panel cover.
