Honeywell EQUIP Series, Installation And Configuration Manual

Page: 78 / 148

58
Configuring HDXA, HDXJ, and HDXF Camera Settings
Note WDR is disabled when the auto slow shutter limit is reached or when
the camera enters NightShot mode. It cannot be enabled while auto
slow shutter and/or NightShot are on.
To enable/disable wide dynamic range:
1. From the OSD main menu, press 5 to select Camera Options .
2. Press 9 to select WDR & Motion Detection .
3. Press 1 to set wide dynamic range to ON or OFF (default).
Setting Motion Detection
This feature is only available with HDXJ and HDXF cameras. It is not available with
HDXA cameras.
When motion detection is enabled, any detected motion causes the message
Motion Detected
to be displayed on the screen. The message remains on the
screen until the dome receives a pan, tilt, or zoom command.
Motion detection is automatically disabled as soon as motion is detected to
avoid multiple triggers from the same event. It is turned on again after a one
minute delay.
Pan, tilt, or zoom changes will disable motion detection.
Note If the dome is configured for IntelliBus protocol, for each motion
detect event an IntelliBus motion detect message is sent to the
IntelliBus master.
To enable/disable motion detection:
1. From the OSD main menu, press 5 to select Camera Options .
2. Press 9 to select WDR & Motion Detection .
3. Press 2 to set motion detection to ON or OFF (default).
If ON is selected, the message
Motion Detection Enabled
appears.