Honeywell DCS19W, Installation And User Manual

Page: 38 / 84

34
Visual Indicators
The blue LED is located near the bottom corner of the vertical
output window on the MS2420. When the scanner is ON, the
flashing or constant, illumination of the LEDs indicates the status
of the scanner and the current scan. There is an additional amber
LED next to the scale zero symbol on all MS2420 scanner models
that include a scale (see Figure 27).
No Blue LED
The blue LED will not be illuminated if the scanner is not receiving
power from the host or transformer. They are also not illuminated when all lasers are turned off for any reason.
Steady Blue
When all lasers are active, the blue LED is illuminated. The blue LED will remain illuminated until all lasers are
deactivated.
Steady Blue and Single Blue Flash
When the scanner successfully reads a bar code, the blue LED will flash and the scanner will beep once. If the
blue LED does not flash or the scanner does not beep once, then the bar code has not been successfully read.
Blue LED Off
After a successful scan, the scanner transmits the data to the host device. Some communication modes
require that the host inform the scanner when data is ready to be received. If the host is not ready to accept
the information, the scanner’s blue LED will remain off until the data can be transmitted.
or
This indicates the scanner may be waiting for communication from the host.
Flashing Blue
This indicates the scanner is in configuration mode. A razzberry tone indicates that an invalid bar code has
been scanned in this mode.
or
If the unit is in sleep mode, the blue LED will flash once every 15 seconds.
or
This indicates there is an error active on the diagnostic indicator display (see Error Codes on page 36). The
scanner may continue to operate depending on the type of error.
Steady Amber LED
The amber LED is illuminated when the scale is at zero.
Figure 27. LEDs