Honeywell AlarmNet IGSMHS, Installation And Setup Manual, Page: 42 / 64

IGSMHS Installation and Setup Guide
4-2
 Primary Central Station ID (two-digit hexadecimal number)
 Primary Subscriber ID (four-digit number)

MAC ID and MAC CRC number (located on outside of box and on label inside module) of
the device you are installing.
Once module is registered, you may log out of the AlarmNet Direct website.
Register using the Tamper Switch
Initiate the registration sequence by clicking the Tamper Switch three times.
You can monitor the registration process by viewing the Status Display. The Message
(yellow) LED and the Status (green) LED will blink slowly in unison while registration is in
progress.
Once the registration has been completed successfully, the IGSMHS enters normal operating
mode; the Status (green) LED goes out and the Message (yellow) LED is lit to indicate that
the Power On / Reset message is waiting to be sent. This message will appear at the
receiving station as “E339 C08xx”, where “xx” is the ECP device address. The description
may read “Trouble – Exp. Mod. Reset”. If registration is not validated within 90 seconds,
the IGSMHS times out, and the (green) LED will be lit (solid).
The Power On / Reset message will be sent in ADEMCO High-Speed format if the module is
programmed for zone trigger, 4204 or 2x4204 modes.
If repeated registration attempts time out, check your Internet connection and RSSI level,
and verify that IGSMHS account information has been entered correctly.
Register using the Programming Tool
The interactive registration feature allows the installer to register the IGSMHS through a
series of keyboard commands on the 7720P Programming Tool. This method of registration
lets the installer monitor the registration process.
Registering …
Once the installation is complete, press the [Shift] and the up arrow
[
 ] key on the 7720P. The registration message is sent and the unit
waits for the acknowledgment.
Registration
SUCCESS
If this is a new installation and the city, central station, and
customer numbers have been correctly entered, the IGSMHS is
registered and this message is displayed. The IGSMHS is now in
full service and available for alarm reporting to the central station.
Possible Errors
Registration BAD
Timed Out
Displayed if no response to the registration request is received.
Registration BAD
Pri Sub ID BAD
Indicates the city, central station, or customer number for the
labeled account(s) is not accepted. The ID information was either
entered incorrectly, or the central station failed to pre-authorize
programmed ID numbers with AlarmNet customer service.
Registration BAD
2nd Sub ID BAD
Indicates the city, central station, or customer number for the
Secondary account is not accepted. The ID information was either
entered incorrectly, or the central station failed to pre-authorize
programmed ID numbers with AlarmNet customer service.