Honeywell AlarmNet IGSMHS, Installation And Setup Manual, Page: 37 / 64

Section 3: Programming the IGSMHS
3-19
PROMPTS
ZONE
TRIG.
4204/
2-4204
ENTRY OPTIONS DESCRIPTION
63
Restore Zn7 Y/N
(Y)_
 
[Y], [N] Enables restore reporting for zone 7.
Zone Trigger mode: This prompt will only be
displayed if zone 7 is not used as the conditional
(arming) trigger zone.
UL: Must be set to “Y.”
64
Delay Zn7 (secs)
(00)_
 
[01-15]
[00] = no
delay
Defines the reporting delay in seconds for
zone 7.
Zone Trigger mode: This prompt will only be
displayed if zone 7 is not used as the conditional
(arming) trigger zone.
UL: Must be set to 00.
65
Rpt Zn7 ONLY if
Armed (N)_

[Y], [N]
Reports alarms on zone 7 ONLY if the
conditional zone (zone 4 in 4204 mode; zone 8 in
2-4204 mode) is triggered (armed).
If [N], always reports alarms on zone 7.
2-4204 mode: If any zone is programmed to
"Report Only if Armed," or if tamper is enabled,
skip to Prompt 68: "Use DHCP."
66
Restore Zn8 Y/N
(Y)_
2-
4204
only
[Y], [N] Enables restore reporting for zone 8.
UL: Must be set to “Y.”
67
Delay Zn8 (secs)
(00)_
2-
4204
only
[01-15]
[00] = no
delay Defines the reporting delay in seconds for
zone 8.
UL: Must be set to 00.
NOTE: Prompts 68 through 73 only appear if the Comm Path Choice is IP, or IP&GSM.
68
Use DHCP Y/N
(Y)_
 
[Y], [N] Dynamically allocates the IP addresses (recom-
mended); then skip to Prompt 73: "Enable Pwr
Save". If [N], uses fixed IP addresses.
69
NIC IP Address:
255.255.255.255_
 
12 digit:
xxx.xxx.xxx.
xxx
Enter the 4-part address for this device. The 4
parts of the address must be separated by
spaces (displayed as periods in Review mode).
70
Subnet Mask:
255.255.255.255_
 
12 digit:
xxx.xxx.xxx.
xxx
Enter the 32-bit address mask used to indicate
the portion (bits) of the IP address that is being
used for the subnet address. The 4 parts of the
address must be separated by spaces (displayed
as periods in Review mode).
71
Gateway IP Addr:
255.255.255.255_
 
12 digit:
xxx.xxx.xxx.
xxx
Enter the 4-part address assigned to the
Gateway. The 4 parts of the address must be
separated by spaces (displayed as periods in
Review mode).
72 DNS Serv IP
Addr:
255.255.255.255_
 
12 digit:
xxx.xxx.xxx.
xxx
Enter the 4-part IP address assigned to the
DNS (Domain Name System) server. The 4
parts of the address must be separated by
spaces (displayed as periods in Review mode).
73
Enable Pwr Save
(Y)_
 
[Y], [N]
To meet the 24 hour UL battery backup
requirement, choose "Y" to enable this feature.
If this causes connectivity problems with
certain routers or switches, then choose "N" and
wire the communications module so it is
plugged into a UL listed UPS.
UL: Must be set to Y.