Honeywell AlarmNet IGSMHS, Installation And Setup Manual, Page: 29 / 64

Section 3: Programming the IGSMHS
3-11
trouble message is automatically sent if the module detects no activity on its connection to
the control panel. The message is: 5555 5515 5; restore message is: 5555 5535 5.
Refer to Table 3-4 for 4204 Emulation Mode programming and follow the prompts that
pertain to 4204 or Two-4204 mode. A check mark (

) indicates whether the prompt applies
to that mode.
Alternative Mode Programming
Press the [ENTER] key to begin programming
and
f
ollow the prompts for the mode of
operation being programmed.
NOTE: The central station can remotely block access to local device
programming. If this has been done, the following prompt
appears:
Access to Prog
Mode Denied
Table 3-4: Programming a IGSMHS for Zone Trigger, 4204 Emulation, or Two-4204 Emulation modes.
PROMPTS
ZONE
TRIG.
4204/
2-4204
ENTRY OPTIONS DESCRIPTION
1
Strt Prog Mode?
Y/N_
 
[Y], [N]
Enters programming mode.
2
Enter Password
 
[0-9, A-F,
N, S, T, X,
Y]
If a password has been previously assigned, this
prompt appears.
Enter a 4-digit password (0-9, A-F, N, S, T,
X, Y). The next prompt appears.
3 Program Device?
Y/N_
 
[Y], [N] To begin programming the module, press [Y]
and go to Prompt 10: "Device Mode."
To create a password if none has been assigned,
press [N] and go to Prompt 4: Create Password.
To change an existing password, press [N] and
go to Prompt 5: "Change Password."
4
Create
Password?
Y/N_
 
[Y], [N] Passwords can be used to protect account and
programming information.
If no password has been assigned, this prompt
appears after pressing [N] at the "Program
Device?" prompt.
If a password is desired, press [Y] and go to
Prompt 6: "Enter Password."
5
Change
Password?
Y/N_
 
[Y], [N] If a password has already been assigned, this
prompt appears after pressing [N] at the
"Program Device?" prompt.
Press [Y] if you want to change the password.
NOTE: To clear an existing password, without
entering a new one, answer [Y] to the "Change
Password?" prompt, then press the [Enter] key
when prompted for the new password and its
confirmation.
6
Enter Password
 
[0-9, A-F,
N, S, T, X,
Y]
This prompt is displayed if [Y] was pressed in
Prompt 4 or 5.
Enter a 4-digit password (0-9, A-F, N, S, T,
X, Y).
Re-enter the password as confirmation.
If the password doesn't match the first entry,
the following is displayed followed by the "Exit
Prog. Mode?" prompt:
7
Verify Password
 
[0-9, A-F,
N, S, T, X,
Y]
Verify Not OK
PSWD not created