Honeywell AlarmNet IGSMHS, Installation And Setup Manual, Page: 15 / 64

Section 2: Mounting and Wiring
2-5
TRIGGERING DEVICE
GSMV-006-V0
GND
GND
ZONE INPUT Z1/Z2
2
1
4
5
TB1
TRANSFORMER
AC INPUT 2
AC INPUT 1
-
TRIGGER
(VOLTAGE 4 to 0V)
COMMUNICATIONS
MODULE
J1
BATTERY
Figure 2-4. Wiring Zone 1 Input for a Ground (-V) Trigger
iGSMBR-010-V0
GND
ZONE INPUT Z1/Z2
2
1
4
5
TB1
TRANSFORMER
AC
AC
2K EOL
RESISTOR
N.C.
N.O.
COMMUNICATIONS
MODULE
J1
BATTERY
Figure 2-5. Wiring Zone 1 Input for EOL Supervised N.O. / N.C. Triggers
Wiring for Module Fault Relay
You may wire and program the module's fault output trigger for fail-safe mode (see the
prompt "FLT REL ON Y/N").
To sense a module fault at the control panel, make connections as shown in
Figure 2-6 ,
including the proper EOL resistor required by the control panel.
UL
For Commercial Burglary, a 24 hour zone (supervisory) must be assigned on the
control panel, with the communication module's fault relay wired to that zone.
iGSMBR-011-V0
12V AUX
GND
ZONE IN (+)
2K EOL
RESISTOR
CONTROL PANEL
GND
ECP (+) VOLTAGE INPUT
2
1
4
3
TB1
TRANSFORMER
AC INPUT 2
AC INPUT 1
RAD FLT
11
COMMUNICATIONS
MODULE
J1
BATTERY
Figure 2-6. Wiring the Fault Relay to a Control Panel Zone for Normally Closed Fault
UL

Zones should use EOL resistors, and be pro-
grammed as V+ Inverted or V– Inverted
operation such that a cut line results in an
alarm.

EOL resistors must be UL Listed.

Do not use zones 1 and 2 for UL
installations.