Honeywell AlarmNet IGSMHS, Installation And Setup Manual, Page: 21 / 64

Section 3: Programming the IGSMHS
3-3
KEY NORMAL KEY FUNCTION SHIFT KEY FUNCTION
6 / F [6]: For entering the number 6 [F]: For entering letter F
7 / S [7]: For entering the number 7 [S]: For entering letter S
8 / T [8]: For entering the number 8 [T]: For entering letter T
9 / X [9]: For entering the number 9 [X]: For entering letter X
SPACE [SPACE]: For scrolling option list No SHIFT function
0 [0]: For entering the number 0 No SHIFT function
# / ENTER [#/ENTER]: Starts programming mode;
Press to accept entries No SHIFT function
* Active only when the "Exit Programming Mode" prompt is displayed.
Using the Control Panel Programming Mode
Most control panels support programming of the IGSMHS through the control panel
programming mode (refer to the control panel’s installation guide). If programming
through the control panel, only the ECP Mode programming options are available. The
"mode" prompts will not be displayed, and the mode cannot be changed. For a
description of key functions on the control panel keypad, and how they map to the
7720P Programming tool, refer to the control panel's Programming Guide.
Programming Conventions
Programming is accomplished by answering a series of prompts. Most prompts require only
a [Y]es or [N]o response, while others require a numerical response (ID numbers, etc.).
The current value is displayed on the second line in parentheses ( ). A "?" indicates an
invalid entry.
Use the [ENTER] key to accept the current entry and proceed to the next prompt. If the
entered value is invalid, pressing [ENTER] re-displays the prompt; the next prompt is not
displayed until a valid answer is entered.
Use the up / down arrow keys to scroll through the programming prompts without changing
any values. Press the [ESC] key to go to the end of the list of prompts.
ECP Mode Programming
The IGSMHS supports ECP messaging via the control panel’s ECP bus. These messages are
in Contact ID format. (Not all control panels support the ECP bus, so be sure to check the
control panel’s Installation and Setup Guide to see if it supports this feature.)
Press the [ENTER] key to begin programming.
NOTE: The central station can remotely block access to local device
programming. If this has been done, the following prompt appears:
Access to Prog
Mode Denied
Table 3-2: Programming an IGSMHS for ECP mode only.
PROMPTS ENTRY OPTIONS DESCRIPTION
1
Strt Prog Mode?
(Y/N)_
[Y], [N]
Enters programming mode.
2 Enter Password:
[0-9, A-F, N, S,
T, X, Y] If a password has been previously assigned, this
prompt appears.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
The next prompt appears.