Honeywell ACUIX, User Manual

Page: 84 / 148

84
On-Screen Setup Menus
Honeywell Diamond Protocol
HEGS5000/HEGS5001 Controller
When using the ACUIX dome in Honeywell Standard mode, the HEGS5000 or HEGS5001
controller is recommended. To access the on-screen setup menus using the HEGS5000
or HEGS5001 controller, perform the following procedure:
1. To access the ACUIX setup menus from the HEGS5000/HEGS5001, you must be
logged in as a Master user on the controller.
2. Press Dome Menu.
3. Press Enter to access the Dome Setup menu. The on-screen menu displays on the
monitor where the ACUIX video is viewed.
Note If password protection is enabled on the ACUIX, you must log into the ACUIX
with a supervisory password.
4. To access a submenu, press the number beside the menu option. The numbers
either toggle between the available choices or call up another menu.
5. If character entry is required in a field, press + or - until the desired character
displays on the LCD screen, and then press Character Select. The controller sends
the character to the ACUIX.
6. Press Clear/Manual to exit any ACUIX menu. Once you are out of the on-screen
setup menus on the monitor, press Menu ESC to exit the menus on the LCD display
and return to controlling the camera.
Note The HEGS5000/HEGS5001 controller does not support reverse polarity.
HJZTP Joystick Controller
The HJZTP controller can also be used with the Diamond protocol. Perform the following
procedure to access the ACUIX on-screen setup menus:
1. A user must be logged in as User Level 1 on the controller to access the ACUIX
on-screen menus.
2. Access the ACUIX dome menu by pressing and holding Lock, followed by F6
(Menu).
3. With
SETUP
flashing on the LCD screen, press Aux.