2 of 14
AII 22054 (0104)
© 2001 American Honda Motor Co., Inc - All Rights Reserved.
Template
2 Flange nuts, 8 mm
4 Screws, 4 x 10 mm
4 Plain-washers, 8 mm
Owner's manual
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by “do-it-yourselfers.”
1.
If equipped, make sure you have the anti-theft
code for the radio, then write down the
frequencies for the preset buttons.
2.
Disconnect the negative cable from the battery.
3.
Get the roof template. Using scissors, cut out
the center of the roof template.
4.
Position the template on the headliner, and
secure it with masking tape. Mark the headliner
as indicated on the template with a felt-tip pen
(two places).
MONITOR
CONSOLE
i-VES
HARNESS
20-PIN CONNECTORS
VCP
VCP
CONSOLE
2 Sponge pads
Illustration of the
i-VES
Installed on the Vehicle
Cut out the marked
area from the
headliner.
FELT-TIP PEN
UTILITY
KNIFE
Strip of
masking tape
TEMPLATE
5.
Remove the template. Using a utility knife, cut
out the marked areas of the headliner. Remove
and discard the cut pieces of the headliner and
the insulation.
FRONT VENT
FRONT
VENT
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
Ratchet
7 mm, 8 mm, 12 mm, 13 mm, and 14 mm Sockets
10 mm Deep socket
Torx bit (T25)
Torque wrench
Utility knife
Masking tape
Electrical tape
Shop towel
Scissors
Piece of wire about 3 ft long
Flat-tip pen
