Honda GOLDWING GL1800, Service Manual

Page: 301 / 757

CLUTCH
9-18
INSPECTION
LIFTER JOINT PIECE, LIFTER BEARING
Check the lifter joint piece for damage or abnormal
wear and the oil passages in the joint piece for
debris.
Turn the lifter joint piece in the lifter bearing with
your finger. The bearing should turn smoothly and
quietly.
Also, check that the bearing races fit tightly in the
lifter plate and joint piece.
Replace the bearing as follows if the bearing does
not turn smoothly, quietly, or if the races fits
loosely.
Remove the snap ring and lifter joint piece.
Remove the snap ring and drive the bearing out of
the lifter plate.
Drive a new bearing into the plate with its mark side
facing up.
Install the snap ring into the lifter plate groove
securely.
Install the lifter joint piece into the bearing and
secure it with the snap ring.
CLUTCH DISC
Replace the clutch
discs and plates as
a set.
Check the clutch discs for signs of scoring or
discoloration.
Measure the clutch disc thickness.
CLUTCH PLATE
Replace the clutch
discs and plates as
a set.
Check the plates for discoloration.
Check for plate warpage on a surface plate using a
feeler gauge.
TOOLS:
Driver
07749–0010000
Attachment, 32 x 35 mm 07746–0010100
Pilot, 17 mm 07746-0040400
SNAP RING
BEARING
SERVICE LIMIT: 3.5 mm (0.14 in)
SERVICE LIMIT: 0.30 mm (0.012 in)