Honda GOLDWING GL1800, Service Manual

Page: 500 / 757

BRAKE SYSTEM (Standard)
15-23
Apply grease to the pivot shaft groove of the pivot
arm.
Place the master cylinder/pivot arm assembly into
the frame while pushing the water hose aside and
insert the pivot arm into the pivot hole, being care-
ful not to damage its splines.
Install the master cylinder onto the frame and
tighten the mounting bolts.
Install the return spring into the pivot arm and onto
the frame stopper pin.
Apply brake fluid to a new O-ring and install it onto
the reservoir joint.
Install the reservoir hose joint into the master cylin-
der and secure it with the snap ring.
Connect the brake hose to the master cylinder with
the oil bolt and new sealing washers, and tighten
the oil bolt.
Install the brake pedal by aligning the slit with the
punch mark on the pivot arm.
Install the pinch bolt and tighten it.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
MASTER
CYLINDER
SPRING
PIVOT ARM
Make sure the snap
ring is firmly seated
in the groove.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
TORQUE: 26 N·m (2.7 kgf·m, 20 lbf·ft)
BOLT
ALIGN
PEDAL