Honda GOLDWING GL1800, Service Manual

Page: 621 / 757

STARTER/REVERSE SYSTEM
19-38
Remove the nuts and reverse shift actuator cables
from the cable holder, and disconnect the cables
from the actuator pulley.
Remove the three bolts and the reverse shift actua-
tor from the crankcase.
Install the reverse shift actuator onto the crankcase
and tighten the three bolts securely.
Connect the R (reverse) cable to the pulley on the
“R” mark side and N (neutral) cable on the “N”
mark side.
Install and tighten the lock nuts.
Adjust the actuator cables.
Install the following:
– ABS modulators (page 16-31)
– right engine side cover (page 2-5)
REVERSE SHIFT ACTUATOR CABLE
ADJUSTMENT
Remove the following:
– right engine side cover (page 2-5)
– center inner fairing (page 2-10)
Check that the reverse shift actuator pulley is in the
neutral position as shown.
Check the N cable clearance between the cable
outer end and cable holder.
Check the R cable clearance between the cable outer
end and cable holder.
Loosen each lock nut and adjust the clearance by
turning each adjusting nut as required.
N CABLE “N” MARK PULLEY
R CABLE “R” MARK BOLTS
REVERSE SHIFT ACTUATOR
PULLEY (REVERSE POSITION)
CLEARANCE: 0 mm (0 in)
CLEARANCE: 0.3 – 0.8 mm (0.01 – 0.03 in)