HOLZMANN Maschinen Austria www.holzmann-maschinen.at
Strana 44
Formátovací pila / panel saw TS 250F-1600
15
MAINTENANCE AND CARE
A T T E N T I O N
Don’t clean or do maintenance on the machine while it is still connected to the
power supply:
Damages to machine and injuries might occur due to unintended switching on of
the machine!
Therefore: Switch the machine off and disconnect it from the power supply before
any maintenance works or cleaning is carried out
The machine is low maintenance and contains little parts that must undergo a maintenance oper-
ator.
Faults or defects that may affect the safety of the machine, must be rectified immediately.
Repair work may only be performed by qualified personnel!
The complete and utter cleaning ensures a long life for the machine and represents a safety re-
quirement.
After each shift the machine and all its parts must be thoroughly cleaned by the dust and swarf
sucked through the suction system and all other waste is disposed of by compressed air.
Check regularly that all warning and safety instructions on the machine and available in a perfect-
ly legible condition.
Check before every use the perfect condition of the safety devices.
For storage of this machine may not be stored in a humid room and must be protected from the
influence of weather conditions.
+
The elimination of defects does your dealer
+
Repair work may only be performed by qualified personnel!
15.1
blade change
Disconnect the machine from the power supply prior to any checks performed
at the machine itself !
CAUTION
:
When mounting and blade change always use protective gloves!
•
Set the saw blade to tilt 90 °
•
Remove the blade guard cover.
•
Move the sliding table all the way to the right and secure
with fixing bolt.
•
Open the safety cover -Saw blade-
•
With a wrench the motor spindle is secured to the shaft
on the motor.
•
With the spanner the 6-square nut is screwed clockwise.
•
The flange and remove the blade.
•
Place the new blade in the
correct direction of rotation.
•
Flange and replace with 6 hexagon nut anticlockwise.
Summary of Contents for TS 250F-1600
Page 62: ......
