HOLZMANN Maschinen Austria www.holzmann-maschinen.at
Strana 40
Formátovací pila / panel saw TS 250F-1600
14
OPERATION
14.1
Adjustments
before initial
+
Before any adjustments, the machine must be disconnected from the power supply to avoid
the risk of accidental switching on the machine!
+
Check that the set speed for the saw blade used is not too high.
+
Span only saw blades with a diameter of
254
mm.
14.2
Operation
14.2.1
Saw blade start / stop
If you want to press the
ON OFF
switch, the combined
EMERGENCY STOP switch must be in the open state.
•
To start, press the green button
˝ I ˝
•
To start, press the red button
˝ O ˝
INFO:
In the closed state of the main switch can be operated as an
EMERGENCY STOP
switch.
14.2.2
Setting the cutting length
The cutting length
can
be set on the
rip fence
guide so that
it is
read
on the
graduated scale
.
With the clamping screw
, this
can be fixed.
(
Fig. 9
)
14.2.3
Saw blade height adjustment
To adjust the height of the material of the blade, turn the handwheel
A
(
Fig. 20
) clockwise
around the blade upward to lift. Turn to lower it to the left.
The blade should protrude approximately
5 mm
from the workpiece.
After adjusting the height with the clamp screw / lever clamp
B
A
Fig. 21
Summary of Contents for TS 250F-1600
Page 62: ......
