HOLZMANN Maschinen Austria www.holzmann-maschinen.at
Strana 37
Formátovací pila / panel saw TS 250F-1600
•
The two nuts (
D
) firmly.
•
The angle brackets using the 4 screws (
F
)
tighten.
13.2.5
Install sliding table support
•
Insert the T-bolt with the bracket in the basic profile of the
sliding table and tighten by turning the prop.
(Fig. 14)
13.2.6
Screw the sliding table handle and lo-
cking pin
•
The T-nut
M12x1,75
push in the slide profile.
•
The handle and tighten with a wrench SW17.
•
Install the locking bolt bracket with 2 screws
M6x10
13.2.7
Install Sliding table extension
•
Slide two
M12x55
T type bolts into the slot of
the sliding carrier, let the crosscut table attach to
the sliding panel.
•
Place the cross-cut table (A) onto the swing arm
assembly and install it on the M20 screw.
•
Use two ratchet handle mounted the cross-cut
table to sliding panel.
•
Adjust the thin two nuts
M16 (B)
to adjust the
cross cut table on the line with sliding panel.
•
Then tighten the two thin nuts
M16
(
B
) and the
thin nut
M20 (C).
D
E
F
clamping lever
Fig. 13
Fig. 14
Fig. 15
B
C
Fig. 16
Summary of Contents for TS 250F-1600
Page 62: ......
