HOLZMANN Maschinen Austria www.holzmann-maschinen.at
Strana 41
Formátovací pila / panel saw TS 250F-1600
14.2.4
Setting angle of intersection
The handwheel
B (Fig. 21)
serves the incline of the saw blade from
90
°
set at
45 °
.
14.3
sectional variations
Longitudinal sections, long sections
Here's to accomplish through the rip fence the side guide.
In blanks with a width of
less than 120 mm
for feeding the work-
piece
MANDATORY ON SLIDING STOCK TO USE!
Cross sections, short sections
For this purpose, the angle-adjustable miter gauge to be used.
Bring these In the position 90 ° to the saw blade and place the workpiece thereon on.Supportive
can, for example, be used for repeated cutting at the same width, the rip fence as an additional
lateral support.
Cuts at an angle
For this purpose,
the
angle-adjustable
miter gauge
to be used.
Bring
these
to the desired angle
to the saw blade
and place the
workpiece
thereon
on
.
to Note
Before each use
to make sure
the
proper state
of the machine
!
That
in particular
: Blade
sharpened
and
without
cracks or other damage
(
injury
!!!
),
splitting
wedge
min
.
Tightened
3mm
distance from
the saw blade
teeth
,
EMERGENCY
OFF
switch
function-
al,
all connections
and
stable
etc
...
edging shoe
The edging shoe serves to avoid a workpiece kickback.
Longitudinal cutting of plates
Setting the acceptance by scale miter on.
Workpiece support table on boom and fixation with
retention.
Feed with sliding table.
Use with decreasing width under 120mm disc Stock
Sliding stock
Summary of Contents for TS 250F-1600
Page 62: ......
