ASSEMBLY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
45
BF500D | BF500DDRO
17.1.6
Vertical alignment milling unit
The machine head is swivelled for transport and must be
brought into the desired position before start-up.
Loosen (but do not unscrew!) the three hexagon nuts (M) on
the turntable and turn the machine head to the desired
position with the aid of the supplied square wrench (K).
Then retighten the hexagon nuts firmly.
17.1.7
Visual inspection
NOTICE
Lubricants are toxic and must not be released into the environment!
Always follow the manufacturer's instructions and, if necessary, contact
your local authority for information on proper disposal.
Supply gear oil (recommended for ISO 12925-1 CKD, DIN51517 Part 3 CLP, US Steel 224, AGMA
9005-E02) with a viscosity of 220.
Check the lubrication of the following parts and top up with suitable oil if necessary before
working on the machine:
Vertical spindle gear
Make sure that the oil level always reaches the
mark of the sight glass (1). Check the oil level
regularly.
Feed gear
Make sure that the oil level always reaches the
mark of the sight glass (2). Check the oil level
regularly.
17.1.8
Filling with coolant
NOTICE
Coolants are toxic and must not be released into the environment! Follow
the manufacturer's instructions and contact your local authority for
information on proper disposal if necessary. Operating the coolant pump
without coolant in the tank can permanently damage the pump.
High temperatures occur at the cutting edge of the tool due to the frictional heat. The tool should
therefore be cooled during turning. Cooling with a suitable coolant will improve the work result
and prolong the tool life. Therefore, fill with coolant. Use a water-soluble, environmentally
compatible emulsion as coolant, which is available from specialty retailers (e.g. KSM5L).
