108
E
qu
ip
m
en
t
-
5
2012 Trip
tv entertaInment componentS
The following paragraphs will discuss the
operations and various components that make
up the entertainment center.
INFORMATION:
It is recommended to become familiar
with individual components. Refer
to the respective component’s OEM
manual for detailed instructions.
NOTE:
All components of the entertainment
system require 120 Volts AC to
operate. Hook to shore power, start the
generator or turn on the inverter. The
satellite system (if equipped) requires
12 Volts DC to operate. Turn on the
interior house power using the battery
cut-out switch.
Television (Front) Lockout Feature
The ignition switch controls the outlet for
the front TV, allowing the front TV to operate
only when the ignition is off. Viewing time
of the front TV from the inverter depends on
state of charge of the house batteries and any
additional 12 Volt DC lighting used.
tv antenna
The television (TV) antenna with built-in
electronics use 12 Volts DC to “boost” signal
strength. Directional control, amplifier and
attenuator are located on the antenna base. The
Antenna Select switch, located in the bedroom
(under the bedroom TV), switches between
either roof antenna or shore cable if available.
Directional control and the attenuator
provide the best possible picture for most
situations depending on location. Certain
reception conditions may occur where
amplification can degrade picture quality.
To Use the Roof Antenna:
Turn on Antenna Select switch.
Turn on Signal indicator.
Rotate Attenuator fully clockwise.
Press inwards on lock to directional
control then rotate antenna until
maximum number of signal strength
lights illuminate.
Rotate Attenuator counterclockwise
until maximum number of signal
strength lights illuminate.
Rotate antenna until strongest signal
indicator flickers then adjust attenuator
counterclockwise until maximum
number of signal strength lights
illuminate.
Antenna direction and attenuator is
now set for the best possible picture.
NOTE:
The Antenna Select switch must be
on to power the attenuator and signal
strength lights.
NOTE:
Rotation control stops allow the
antenna to rotate 360º.
NOTE:
Rotate direction control knob with
arrow pointing rearward for travel.
To Use Shore Cable:
Turn the Antenna Select switch off.
Make the cable connection to the shore
cable port located on the water service
center panel.
On/Off
Attenuator
Control Lock
Direction Control
Power On
Signal Lights
031752h
Antenna select switch
located in bedroom
030752i
031319c
Summary of Contents for Trip 2012
