176
C
ha
ss
is
E
le
ct
ri
ca
l
-
9
2012 Trip
Right Control
Marker Flash:
Pressing Marker
Flash causes the taillights and all
marker lights to momentarily illuminate with
the headlights off. Pressing Marker Flash with
the headlights on will cause all marker lights
and taillights to go off.
Wiper Function
Turning on any wiper function will turn on
the headlamps. To turn the headlights off; turn
off the ignition, or activate then deactivate the
dashboard headlamp switch.
Off:
Cancels all wiper operations. Wiper
function is also cancelled when the ignition is
turned off.
Hi-Lo:
When the button is pressed, wipers
activate on low speed. If the button is pressed
again, the high wiper speed setting is activated.
Subsequently pressing the Hi-Lo button will
alternate wiper operation between low and
high speed mode.
Wiper Wash:
Activates the wash pump
relay while the button is pressed. If no wiper
function is selected, the low wiper will activate
for a period of approximately three wiper
cycles, after the switch is released. If any
wiper functions are selected, the wipers will
continue to run in the selected mode after the
wash button is released.
Wiper Variable:
Pressing the Wiper
Variable button activates the wipers on low
speed for one wipe. If the button is pressed
again within approximately 30 seconds,
the low speed wiper function activates and
repeats at an interval determined by the time
between the last two operations of the button.
Additional button operations will shorten the
cycle. Activating other wiper modes cancels
the variable wiper mode.
Example:
In light rain or misting conditions
press the button once to initially clear the
windshield. When the windshield requires a
second clearing, press the button again. This
sets the timed interval between subsequent
wipes. To extend the wipe interval, press the
intermittent button twice or switch the wipers
off and use the same method to set the desired
interval.
Tilt & Telescope
Tilt and telescope settings are set by a lever
on the steering column.
To Tilt:
Pull the lever up and tilt the steering
wheel to the desired level.
Release the lever to lock the steering
wheel in the new position.
To Telescope:
Push and hold the lever down.
Move the steering wheel to the desired
location.
Release the lever to lock the steering
wheel in the new position.
Turn Signal Lever
A turn signal lever is located on the steering
column. The ignition must be on for the
signals to operate.
To Activate:
Push the lever forward to activate right
turn indicator.
Pull the lever back to activate left turn
indicator.
NOTE:
A turn signal minder is activated with
turn signal operation. Applying the
brake cancels the turn signal minder.
Turn Signal Indicator on Mirror:
For
safety, a turn signal indicator is mounted on
side mirror.
090243b
Summary of Contents for Trip 2012
