10
Draining the Holding Tanks
Dumping the Tanks:
1. Connect sewer hose to drain terminal.
2. When preparing to dump the solid waste (Black) tank, first
close the liquid waste (Grey) tank valve.
3. Fill the liquid waste (Grey) tank to at least 50% by running
water in the shower or sinks.
4. Use the monitor panel to observe tank fluid levels. When the
liquid waste tank is 50% full stop filling the tank.
5. Open the solid waste (Black) tank valve. Allow the solid waste tank to
drain then close the black tank valve.
6. Open the liquid waste (Grey) tank valve. The water in the liquid waste
(Grey) tank flushes any remaining solids from the hose. With the liquid
waste (Grey) tank valve open, run two gallons of water down any drain to
flush the liquid waste (Grey) tank. The liquid waste valve remains open
until the next drain cycle or departure.
7. If preparing for travel, close all valves. Disconnect the hose from the
termination outlet by rotating the fitting counterclockwise 90º.
8. Raise hose and using hand over hand method working hose
towards shore fitting. This will help drain hose. Rinse the hose with outside facility and repeat the hose
drain process.
9. Remove the hose from shore fitting and store hose. Secure the termination cap (required by law in some
states).
10. If desired, add chemicals to the tanks to control odor. Follow the chemical manufacturer’s directions.
NOTE:
Dump the solid waste tank before driving.
toIlet
Lever Flush
The toilet operates from either fresh water tank or city water supply. The water pump
must be turned on or the city water connected. The toilet flushes directly into a sewage
holding tank (black water).
Flushing the Toilet:
The hand operation uses one lever, located on the back right side of the toilet (when
facing the toilet).
Pull the lever forward to the Add Water position (half way between the start position
and the flush position). This allows the bowl to fill with water before use. Generally,
more water is required when flushing solids.
Pull the lever forward completely to flush the toilet. Release when the bowl empties.
Pedal Flush
The toilet operates from either the fresh water tank or city water supply. The water pump must be turned on or
the city water connected. The toilet flushes directly into a sewage holding tank (black water).
NOTE:
To prevent accumulation of solids below toilet, add several gallons of water to the holding tank before
use.
040399b
040399b
030834b
040422i
Typical Connection