26
V60T/July 2020/V1.1
It is the responsibility of the operator to make sure the workpiece offers the best basis for the
magnetic drilling machine to adhere and that the machine is secure before use.
1)
Place the machine on the workpiece
2)
Connect the machine to the power supply
3)
Position the machine in the exact desired spot
4)
Press the red magnet switch to activate the magnet, the magnet switch will illuminate.
5)
To deactivate the magnet, press the red magnet switch again
Make sure that the magnet attaches securely to the work piece before starting the motor unit of the
magnetic drilling machine. HMT magnets have 2 coils; make sure that both coils are in contact with
the workpiece. Do not connect any other machines to the same electrical outlet the machine is
plugged into, as this could result in the loss of magnetic force.
We need to point out that this is only an indication and not a certainty that the magnet will not
release from the material. HMT accepts no liability for insufficient adhesion from any cause.
ALWAYS use the safety strap included.
Drilling above your head is extremely dangerous and is not recommended. For the use of magnetic
drilling machines on pipes, curved or non-magnetic materials, we refer you to our website
www.holemaker-technology.com where several pipe clamping & drilling systems can be found.
5.5
Emergency Stop
In case of emergency, to quickly stop the motor spindle rotating, hit the RED STOP button on the
motor switch. This switch is both raised and unshrouded to enable it to be accessed quickly in an
emergency. See [Image 16] below.
By hitting the motor stop this will stop the motor but leave the magnet energized for safety.
[image 16]
